Hach-lange ORBISPHERE K1100_M1100 Operator Manual Manuel d'utilisateur télécharger pdf (Page 29)

Installation

3.4.2 Mounting

Figure 9 Panel mount bracket frame

1. Cut an opening in the panel to accommodate

the bracket frame provided (this is the same

size as previous generations of ORBISPHERE

type 3600 instruments).

Figure 10 Opening dimensions

2. Install the provided frame in the opening.

3. Fold the 6 tabs over the panel lips, using

adjustable joint pliers.

4. Slide the instrument in the bracket frame. The

instrument should go over the four “T” pins.

Rotate the 4 fast locking screws on both sides of

the front panel and slide it in.

5. Rotate the 4 fast locking screws 1/4 turn twice in

the lock direction as indicated on the side of the

front panel. This locks the instrument in place on

the four “T” pins.

6. To access the connections inside the

instrument, remove the instrument housing (six

screws on the back panel, and slide the housing

back out)

7. Pass the cables through the housing, then

through the cable gland (if applicable) and then

perform the connections as detailed below.

Note: Do not forget to pass the cable through the housing

before passing it through the cable gland on the back

panel.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 113 114

Pas de commentaire

Hach-lange ORBISPHERE K1100_M1100 Operator Manual Manuel d'utilisateur Page 29