Hach-lange ORBISPHERE K1100_M1100 Operator Manual Manuel d'utilisateur télécharger pdf (Page 34)

Installation

Wire the female connector as follows:

1. Take the narrow end of the connector (4) in one hand and the main body (2) in the other

and unscrew the two. Pull away the cable clamp (3) and unscrew the end plug (1) to reveal

the four parts that make up the connector.

2. Loosen the screws on the cable clamp (3) to allow enough room to pass the power cable

through.

3. Pass the power cable through the end plug (1), the main body (2), and the cable clamp (3),

and then connect the three wires (live, neutral and earth) to the connector (4) as follows:

4. Slide the cable clamp (3) back onto the connector (4) and tighten the screws on the clamp

to secure the cable.

5. Screw the two parts (4) and (2) back together.

6. Secure the power cable by screwing the end plug (1) back in place.

7. The female connector can now be plugged directly into the instrument power connector. The

two connectors are grooved to avoid an incorrect fitting. Tighten the female connector to the

instrument power connector finger-tight.

1) Live (brown)

2) Neutral (blue)

3) Not used

Earth (green and yellow)

Note: The numbers and earth

symbol are stamped on the end of

the connector. Ensure it is connected

correctly.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 113 114

Pas de commentaire

Hach-lange ORBISPHERE K1100_M1100 Operator Manual Manuel d'utilisateur Page 34