Hach-lange ORBISPHERE K1100_M1100 Operator Manual Manuel d'utilisateur télécharger pdf (Page 92)

Products Menu

Products

This option allows users to save and/or use previously saved product configurations. A maximum of 100

different product configurations can be stored in the instrument. The basic measurement configuration

(gas to analyze, gas unit, alarm limits, analog outputs, etc.) can be set up for a product and will be

automatically used by the instrument when that product is selected.

Product configurations can be moved from instrument to instrument if required. However, as the sensor

only analyzes oxygen, only products configured to analyze oxygen can be selected on this instrument.

Products configured to analyze other gases can, however, be set up on this instrument and easily

transferred to other 410 or 51x instruments analyzing gases other than oxygen.

For ease of use, where product configurations are identical or similar, a Copy facility exists on the modify

product screen. This enables copying a stored configuration and storing it in one or more additional

locations. Then use the modify product option to identify and/or modify the duplicate configurations.

Select product Note: If the PROFIBUS-DP communications protocol has been enabled,

products can be selected for analysis using that facility (see Input/Output

data on page 78 and specifically Change product command - output on

page 80 for details).

• Select the product (0-99) to be analyzed, or use the Next and Previous

buttons to scroll sequentially through the existing product list.

Alternatively, use the Search facility to search for a product. Enter a full

or partial search criteria. If only one match is found, this product is

automatically selected. If a number of products match the search

criteria, then a list of matches will be displayed. Select a product directly

from the list of matching products.

• Press OK to select the product or Cancel to exit.

Modify product • Select the product (index 0-99) to modify, or use the Next and Previous

buttons to scroll sequentially through the existing product list.

Alternatively, use the Search facility to search for a product. Enter a full

or partial search criteria. If only one match is found, this product is

automatically selected. If a number of products match the search

criteria, then a list of matches will be displayed. Select a product directly

from the list of matching products.

• Select the gas to analyze (up to three can be selected) from the drop

down list.

• After selecting a product and gas, press Configure to configure the

product. Configure the product as required (refer to Measurement

configuration on page 52 for additional information).

• Press Analog out to configure the analog outputs. Configure the analog

output as required (refer to Channel configuration on page 65 for

additional information).

• Press OK to accept the configuration, or Cancel to exit.

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 113 114

Pas de commentaire

Hach-lange ORBISPHERE K1100_M1100 Operator Manual Manuel d'utilisateur Page 92