Hach-lange ORBISPHERE K1100_M1100 Operator Manual Manuel d'utilisateur télécharger pdf (Page 18)

Specifications

The oxygen partial pressure (pO

) is then linked to the corresponding phase-shift measurement

(Φ) to build the sensor calibration curve (shown right in Figure 3). This curve is described by the

Stern-Volmer equation (shown left in Figure 3) where K

is the indicator quenching constant (in

mbar

-1

) representing the quenching efficiency of the oxygen and thus the sensor sensitivity, f

a constant and Φ

is the phase-shift at zero oxygen representing the unquenched fluorescence

decay time of the dye. The calibration curve thus relies on two parameters: the phase-shift at

zero oxygen and the luminescent spot sensitivity, K

. The dissolved oxygen concentration is

then calculated with Henry’s law using the water solubility curve as a function of the

temperature.

2.4 Hardware description

The instrument hardware is made of one main board, and one measurement board for the

measurement channel (= the sensor).

The main board includes the controls for power, display, the touch screen, the barometric

sensor, the alarms, and communication ports. The measurement board performs measurements

and executes commands from the main board. It holds the "Analog output" and "Relays" that

send information to external systems.

A hardware watchdog is activated at program start up, to check that the system is not frozen

(i.e. infinite loop, system crash, etc.). If the watchdog is not refreshed by the software every

minute, the measurement display, the relays and the analog output are frozen up to 2 minutes.

Then the reset shuts down the instrument for 10 seconds and the start-up procedure is

performed. At the same time all the hardware (sensor, measurement board) are reset.

Figure 3 Stern-Volmer equation and calibration curve

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 113 114

Pas de commentaire

Hach-lange ORBISPHERE K1100_M1100 Operator Manual Manuel d'utilisateur Page 18