Hach-lange ORBISPHERE Model 51x User Manual Manuel d'utilisateur télécharger pdf (Page 35)

Installation

3.6.2 Ethernet connector (table version)

The Harting RJ Industrial® IP 67 Push Pull connector can be locked and unlocked using one

hand and minimal force. Only a few steps are necessary in order to quickly and reliably attach

an Industrial Ethernet cable to the Harting RJ Industrial® connector. Only a Harting cable should

be used.

1. Push the cable gland and housing over the cable

2. Strip the skin on 24 mm and the shielding screen on 13

3. Prepare the individual wires for insertion into the splicing

element, according to the PROFInet® color code (see

PROFInet® color code on page 34)

4. Insert the wires into the splicing element up to the end of

the wire chambers

5. Push the splicing element onto the RJ 45 data module

and engage

6. Put the splicing element and the RJ 45 data module into

the IDC assembly tool

7. Press data module and element together with the aid of

the 1 DC assembly tool

8. Remove the terminated data module from the assembly

tool

9. Put on the upper shielding shell and press it over the

cable screen

10. Put on lower shielding shell and lock it with the upper

shell with an audible "click"

11. Push housing over the installed data module and lock it

with an audible "click"

12. Tighten cable gland

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 115 116

Pas de commentaire

Hach-lange ORBISPHERE Model 51x User Manual Manuel d'utilisateur Page 35